Anritsu LMR Master S412E Programming Manual page 164

5-10 :Trace Subsystem
Table 5-3. Trace Header Parameters (Sheet 3 of 8)
Parameter Name
ACTIVE_TRACE
TOTAL_TRACE
AVERAGING_COUNT
AVERAGING_FACTOR
EXTERNAL_REFERENCE
EXT_REF_FREQ_LIST
SWEEP_TYPE
EXTERNAL_TRIGGER
BIAS_TEE_STATE
BIAS_TEE_PORT_SELECTION
BIAS_TEE_VOLTAGE_Px
INT_BIAS_TEE_VOLTAGE
BIAS_TEE_CURRENT_LIMIT_Px
INT_BIAS_TEE_CURRENT
RF_SOURCE_POWER
CABLE
DIST_UNITS
5-56
Current active trace. Where:
0 is for trace 1, 1 for trace 2, 2 for trace 3, and
3 for trace 4
Total number of traces
Current Averaging Count
Averaging factor
External Reference where 0 is for Off and 1 is for
Locked
Currently not being used.
Sweep type. Available sweep types are:
Single = 0 and Continuous = 1
Currently not being used.
Bias Tee State. Currently available Bias Tee
states are:
Off = 0 and Internal = 2
Bias Tee port selection. Where:
1 is port 2.
Internal Bias Tee voltage, where:
x is the port number.
Return value is 1000 times the current voltage
value in Volts.
Internal Bias Tee voltage. Return value in mV.
Internal Bias Tee current limit, where:
x is the port number.
Return value is in mA.
Internal Bias Tee current limit, where:
x is the port number.
Return value is in mA.
Internal Bias Tee current. Return value is in mA.
Source Power. Current valid source power:
low = 0, and high = 1.
The index of the selected cable list, where 0 is the
first in the list.
Distance units. Available distance units are:
Meter = 0, Feet = 1
PN: 10580-00319 Rev. N
VNA Commands
Description
S412E PM