Anritsu LMR Master S412E Programming Manual page 279

LTE Commands
:READ:RF:ACLR?
Title: Read Adjacent Channel Leakage Ratio
Description: Triggers a new Adjacent Channel Leakage Ratio measurement and
Default Unit: dBm
Front Panel Access: Measurements, RF, ACLR
:READ:RF:SEM?
Title: Read RF Spectral Emmision Mask
Description: Triggers a new RF Spectral Emission Mask measurement and returns a
Front Panel Access: Measurements, RF, Spectral Emission Mask
:READ:RF:SPECtrum?
Title: Read RF Spectrum
Description: Triggers a new RF Spectrum measurement and returns the results:
Related Command: :FETCh:RF:SPECtrum?
Front Panel Access: Measurements, RF, Channel Spectrum
S412E PM
returns the results: Power levels for each channel (both absolute and
relative). If the instrument is sweeping, it will not return until the
sweep is complete. If the instrument is not sweeping and the current
data is not valid it will return error –230. This could occur if there was a
*RST immediately before the :FETCh? or if a measurement parameter
was changed without an :INITiate.
Data is returned as 11 comma-separated values: Main channel power,
Left alternate channel power - relative, absolute , Left adjacent channel
power - relative, absolute,
Main channel power - relative,absolute, Right adjacent channel
power - relative, absolute, Right Alternate channel power - relative,
absolute.
PASS or FAIL result. It is a combination of the commands :ABORT;
:INITiate; :FETCh:RF:SEM?
The current measurement can be queried using :CONFigure?
Channel Power and Occupied BW measurement. It is a combination of
the commands :ABORT; :INITiate; :FETCh:RF:SPECtrum? The current
measurement can be queried using :CONFigure?
Data is returned as 2 comma-delimited values: Channel Power in dBm
and Occupied bandwidth measurement in MHz.
:CONFigure:RF SPECtrum
:MEASure:RF:SPECtrum?
PN: 10580-00319 Rev. N
9-9 :READ Subsystem
9-19