Anritsu LMR Master S412E Programming Manual page 169

VNA Commands
Table 5-3. Trace Header Parameters (Sheet 8 of 8)
Parameter Name
TRACE_x_1PCL_RESOLUTION
TRACE_x_1PCL_REFERENCE
TRACE_x_1PCL_REFERENCE_LINE
TRACE_x_POLAR_RESOLUTION
TRACE_x_POLAR_REFERENCE
TRACE_x_POLAR_REFERENCE_LINE
CAL_METHOD
CAL_TYPE
CAL_LINE_TYPE
CAL_PORTx_DUT
CAL_CORRECTION
APP_SELF_TEST_MODE
DEBUG_MEAS_GAIN_RANGE
LOG_COUNTER_EVENTS
SWEEP_DEFAULT_FREQS
PWRCAL_RF_SWITCH_FREQ
PWRCAL_LOW_RF_HIGH_TARGET
PWRCAL_LOW_RF_LOW_TARGET
PWRCAL_UPPER_RF_HIGH_TARGET
PWRCAL_UPPER_RF_LOW_TARGET
PWRCAL_UW_RF_HIGH_TARGET
PWRCAL_UW_RF_LOW_TARGET
USER_DEFINED_CAL_KIT_NAME
USER_DEFINED_CAL_KIT
TRACE_LABEL_STATE
S412E PM
Log Mag/2 resolution, where x is the trace
number. Returned value is in dB.
Log Mag/2 Reference value, where x is the trace
number. Returned value is in dB.
Log Mag/2 Reference line, where x is the trace
number.
Currently not used.
Currently not used.
Currently not used.
Calibration Method, where:
SOLT = 0
The index of the selected calibration type list,
where 0 is the first in the list.
Calibration Line Type, where coax = 0.
The index of the selected Calibration Coax DUT
Selector list for port x, where 0 is the first in the
list.
Calibration correction, where On = 0, and Off = 1
Internal use only
Internal use only
Internal use only
Internal use only
Internal use only
Internal use only
Internal use only
Internal use only
Internal use only
Internal use only
Internal use only
Internal use only
Internal use only
Trace label On/Off, where On = 0, Off = 1
PN: 10580-00319 Rev. N
5-10 :Trace Subsystem
Description
5-61