General Information
1. Turn On power to the S412E and controller PC and wait for the systems to power up
completely.
2. Connect the USB cable mini-B connector to the S412E.
3. Connect the USB cable A connector to the controller PC USB host port. The controller
PC should indicate "New Hardware Found" if the combination of USB VID/PID/
Serial Number has never been connected to this controller PC.
Figure 1-1.
USB Found New Hardware Wizard
4. Select to allow the Wizard to search for and install the USB software automatically.
Figure 1-2.
USB Found New Hardware Wizard
S412E PM
1-4 Remote Programming Setup and Interface
PN: 10580-00319 Rev. N
1-5