Sense] Subsystem - Anritsu LMR Master S412E Programming Manual

AM/FM/PM Commands

18-7 [:SENSe] Subsystem

The commands in this subsystem relate to device-specific parameters, not signal-oriented
parameters.
[:SENSe]:AFPanalyzer:AVERage:COUNt <avg count>
[:SENSe]:AFPanalyzer:AVERage:COUNt?
Title: Measurement Average
Description: Sets the average count for the measurement data in the summary mode.
Parameter: <number>
Range: 1 to 65535
Front Panel Access: Shift-4 (Measure), Average (only in Summary mode)
[:SENSe]:AFPanalyzer:DEMod:DATA?
Title: Summary data
Description: This query returns the measurment values in the Summary view. The
Front Panel Access: Shift-4 (Measure), Audio Spectrum/Waveform
[:SENSe]:AFPanalyzer:DEMod:MODE RFSP|AFSP|AFWV|SUMMary
[:SENSe]:AFPanalyzer:DEMod:MODE?
Title: Demodulation Mode
Description: This command sets the demodulation mode (graph type) to RF
Parameter: RFSP|AFSP|AFWV|SUMMary
Default Value: RFSP
Example: To set the demodulation mode to Audio Waveform:
Front Panel Access: Shift-4 (Measure)
S412E PM
The query format of this command returns the value only in the
summary mode. The query format returns nothing in other
measurement modes.
order of the values are as follows:
<Modulation rate> in Hz, <RMS Deviation> in % or Hz or Rad
depending on the demod type, <Peak-Peak/2 Dev> in % or Hz or Rad
depending on the demod type, <SINAD> in dB, <THD> in % and
<Distortion> in %. All values are comma separated.
spectrum(RFSP) or Audio Spectrum(AFSP) or Audio Waveform (AFWV)
or Summary.
SENSe:AFPanalyzer:DEMod:MODE AFWV
PN: 10580-00319 Rev. N
18-7 [:SENSe] Subsystem
18-13