Anritsu LMR Master S412E Programming Manual page 632

17-11 :TRACe Subsystem
Table 17-1. Returned Parameter Values in Trace Preamble (Sheet 6 of 7)
Parameter Name
NUMERIC_DISPLAY
DEMOD_TYPE
MOD_BANDWIDTH
RX_SLOT
TX_SLOT
HIGH_PASS_FILTER
LOW_PASS_FILTER
AUDIO_SPECTRUM_SPAN
AUDIO_WAVE_SWEEP_TIME
DEEMPHASIS
SINAD_MAPPING_EXCELLENT
SINAD_MAPPING_VERY_GOOD
SINAD_MAPPING_GOOD
SINAD_MAPPING_FAIR
SINAD_MAPPING_POOR
CARRPWR_MAPPING_EXCELLENT
CARRPWR_MAPPING_VERY_GOOD
CARRPWR_MAPPING_GOOD
CARRPWR_MAPPING_FAIR
CARRPWR_MAPPING_POOR
THD_MAPPING_EXCELLENT
17-28
Determines what values are displayed in the Analyzer
summary window.
Modulation type (used with P25, P25p2, DMR 2, and
PTC).
Modulation bandwidth (used with NXDN and dPMR
only).
Receiver (Rx) time slot selection (Only used for
DMR 2).
Generator (Tx) time slot selection (Only used for
DMR 2).
High pass filter selection (Only used for NBFM). 0 is
300 Hz, 1 is 3 kHz, 2 is None.
Low pass filter selection (Only used for NBFM). 0 is
300 Hz, 1 is 3 kHz, 2 is 15 kHz, 3 is None.
Span for the Audio Spectrum graph in NBFM Analyzer
(Only used in NBFM).
Sweep time for the Audio Waveform graph in NBFM
Analyzer (Only used in NBFM).
State of the De-emphasis filter (Only used in NBFM).
0 is ON and 1 is OFF.
Threshold at which the SINAD mapping value is
deemed excellent (Only used in NBFM).
Threshold at which the SINAD mapping value is
deemed very good (Only used in NBFM).
Threshold at which the SINAD mapping value is
deemed good (Only used in NBFM).
Threshold at which the SINAD mapping value is
deemed fair (Only used in NBFM).
Threshold at which the SINAD mapping value is
deemed poor (Only used in NBFM).
Threshold at which the Carrier Power mapping value
is deemed excellent (Only used in NBFM).
Threshold at which the Carrier Power mapping value
is deemed very good (Only used in NBFM).
Threshold at which the Carrier Power mapping value
is deemed good (Only used in NBFM).
Threshold at which the Carrier Power mapping value
is deemed fair (Only used in NBFM).
Threshold at which the Carrier Power mapping value
is deemed poor (Only used in NBFM).
Threshold at which the THD mapping value is deemed
excellent (Only used in NBFM).
PN: 10580-00319 Rev. N
TETRA Commands
Description
S412E PM