Anritsu LMR Master S412E Programming Manual page 369

P25 Phase 2 Commands
[:SENSe]:DM:FORMat BS|MS
[:SENSe]:DM:FORMat?
Description: Sets the modulation type to Base Station (BS) or Mobile Station (MS).
Cmd Parameters: BS|MS
Query Parameters: NA
Range: BS|MS
Default Value: BS
Default Unit: NA
Example: To set the modulation type to MS:
Front Panel Access: Setup, Mod Type
[:SENSe]:DM:PATTern 1031hz|SILence|VOICe|CTRLchan
[:SENSe]:DM:PATTern?
Description: Sets the receiver pattern type. Please note that setting the Rx Pattern
Cmd Parameters: 1031hz|SILence|VOICe|CTRLchan
Query Parameters: NA
Range: 1031hz|SILence|VOICe|CTRLchan
Default Value: 1031hz
Default Unit: NA
Example: To set the modulation type to voice:
Front Panel Access: Setup, Rx Pattern
[:SENSe]:DM:SQUelch <value>
[:SENSe]:DM:SQUelch?
Description: Sets the squelch power level. The squelch is only applied to the P25p2
S412E PM
Please note that setting the modulation type will restart the sweep.
:DM:FORMat MS
will restart the sweep.
:DM:PATTern VOICe
Analyzer Summary window on the front panel and will blank out (--) all
summary measurements except for Received Pwr when the received
power level is lower than the squelch power setting.
FETCh:SIGAnalyzer?, READ:SIGAnalyzer?, and
MEASure:SIGAnalyzer? will always return all numerical values.
The query will be returned in the units (dBm, Watts, or Volts) selected
through the Rx Units button using the front panel or with the
command: UNIT:POWer:RX. If the Rx Units has been set to dBm, the
squelch setting is returned in dBm. If the unit is set to Watts, the
squelch setting is returned in fW. If the unit is set to Volts, the squelch
setting is returned in fV.
PN: 10580-00319 Rev. N
11-13 [:SENSe] Subsystem
11-41