Anritsu LMR Master S412E Programming Manual page 234

8-2 :CONFigure Subsystem
8-2 :CONFigure Subsystem
This set of commands prepares the instrument for the selected measurement. It disables any
currently-enabled measurements and activates the specified measurement. It sets the
instrument to single sweep mode, waiting for an :INITiate command. It will not initiate the
taking of a measurement.
Current instrument settings may be changed to default values. These changes are identified
with their respective measurement commands.
:CONFigure PFail
Title: Configure PASS/FAIL Measurement
Description: This command configures the PASS/FAIL measurement. It disables any
Parameter: PFail
Related Command: :FETCh:PFail?
Front Panel Access: Measurements, Pass/Fail Mode
:CONFigure SUMMary
Title: Configure Summary Measurement
Description: This command configures the summary of all the related numerical
Parameter: SUMMary
Parameter Type: <char>
Front Panel Access: Measurements, WiMAX Summary
8-2
other active measurements. None of the instrument parameters are
changed by the execution of this command. Sets the instrument to
single sweep mode (:INITiate:CONTinuous OFF). Measurement
settings can be modified by using the [:SENSe] commands before
initiating a measurement. The measurement results are equivalent to
the results that are displayed by choosing Measurements, then
PASS/FAIL from the front panel.
MEASure:PFail?
READ:PFail?
measurement results. It disables any other active measurements. None
of the instrument parameters are changed by the execution of this
command. Sets the instrument to single sweep mode
(:INITiate:CONTinuous OFF). Measurement settings can be modified
by using the [:SENSe] commands before initiating a measurement.
PN: 10580-00319 Rev. N
Mobile WiMAX Commands
S412E PM