Anritsu LMR Master S412E Programming Manual page 270

9-5 :FETCh Subsystem
:FETCh:OTA:C4AGGregation?
Title: Fetch OTA Carrier Aggregation (4x4 MIMO configuration)
Description: Returns the result of the most recent Carrier Aggregation measurement
Front Panel Access: Measurements, Over-the-Air, Carrier Aggregation
:FETCh:OTA:CAGGregation?
Title: Fetch OTA Carrier Aggregation
Description: Returns the result of the most recent Carrier Aggregation measurement
Front Panel Access: Measurements, Over-the-Air, Carrier Aggregation, CC#
:FETCh:RF:ACLR?
Title: Fetch Adjacent Channel Leakage Ratio
Description: Returns the most recent adjacent channel leakage ratio measurement
Default Unit: dBm
Front Panel Access: Measurements, RF, ACLR
:FETCh:RF:SEM?
Title: Fetch Spectral Emission Mask
Description: Returns Spectral Emission Mask measurement results (Pass or Fail).
Front Panel Access: Measurements, RF, Spectral Emission Mask
9-10
numeric results. This command may not be supported if your
instrument is loaded with older firmware, in which case you may
upgrade to the current firmware version or use the
:FETCh:OTA:CAGGregation? command, instead. Refer to your
instrument User Guide for instructions on updating firmware.
Data is returned as 70 comma delimited values. The values consist of
5 sets of Component Carrier (CC) data, with each set containing
14 fields (CP, tx1 antenna, tx2 antenna, tx3 antenna, tx4 antenna,
RS Power, RS Delta Power, SS Power, EVM(rms), EVM(pk),
Freq Error, Freq Error (ppm), TAE (nS), and Cell ID). The data is in
sequential CC order. A field with "--" means the data was invalid. An
inactive Component Carrier will show N/A for the entire set of data.
numeric results. Data is returned as 60 comma delimited values. The
values consist of 5 sets of Component Carrier (CC) data with each set
containing 12 fields (CP, tx1 antenna, tx2 antenna, RS Power, RS Delta
Power, SS Power, EVM(rms), EVM(PK), Freq Error, Freq Error (ppm),
TAE (nS), and Cell ID). The data is in sequential CC order. A field with
"--" means the data was invalid. An inactive Component Carrier will
show N/A for the entire set of data.
results. If the instrument is sweeping, it will not return until the sweep
is complete. Refer to
of the returned data.
PN: 10580-00319 Rev. N
":READ:RF:ACLR?" on page 9-19
LTE Commands
for a description
S412E PM