Fetch Subsystem - Anritsu LMR Master S412E Programming Manual

LTE Commands
9-5

:FETCh Subsystem

This set of commands returns the most recent measurement data of the active measurement.
They will not switch to another measurement.
To make a new measurement, use the INITiate command. To get new measurement data, use
the READ or MEASure query commands.
:FETCh:DEMod:4x4:TIMEalign?
Title: Fetch Tx Time Alignment Data (4x4 MIMO configuration)
Description: Returns the most recent Time Alignment measurement numeric
Front Panel Access: Measurements, Modulation, Tx Time Alignment
:FETCh:DEMod:CCPData?
Title: Fetch Control Power Data
Description: Returns the most recent Control Channel Power measurement numeric
Front Panel Access: Measurements, Modulation, Control Channel Power
:FETCh:DEMod:CONStln?
Title: Fetch Constellation
Description: Returns the constellation measurement numeric results of the
Front Panel Access: Measurements, Modulation, Constellation
S412E PM
results. This command may not be supported if your instrument is
loaded with older firmware, in which case you may upgrade to the
current firmware version or use the :FETCh:DEMod:TIMEalign?
command, instead. Refer to your instrument User Guide for
instructions on updating firmware.
Data is returned as 14 comma-delimited values: EVM (rms) in %,
EVM (pk) in %, Ref Signal (RS) Power in dBm, Sync Signal (SS) Power
in dBm, Carrier Frequency in MHz, Freq Error in Hz, Freq Error in
ppm, Cell ID, and Time Alignment Error (TAE) in nanoseconds for each
of antenna pairs 1-2, 1-3, 1-4, 2-3, 2-4, and 3-4. "--" is returned for each
data that is not valid at that instance.
results.
Data is returned as 24 comma-delimited values: RS_POWER,
PSS_POWER, SSS_POWER, BCH_POWER, CFI_POWER,
RS_TOTAL_POWER, PSS_TOTAL_POWER, SSS_TOTAL_POWER,
BCH_TOTAL_POWER, CFI_TOTAL_POWER, TOTAL_POWER,
TOTAL_CHANNEL_POWER
demodulated data symbol over one sub-frame measurement. Data is
returned as 8 comma-delimited values:
EVM (rms) in %, EVM (pk) in %, Ref Signal (RS) Power in dBm, Sync
Signal (SS) Power in dBm,Carrier Frequency in MHz, Freq Error in Hz,
Freq Error in ppm, and the Cell ID. "--" is returned for each data that is
not valid at that instance.
PN: 10580-00319 Rev. N
9-5 :FETCh Subsystem
9-9