Read Subsystem - Anritsu LMR Master S412E Programming Manual

Fixed WiMAX Commands
7-9

:READ Subsystem

This set of commands combines the ABORt, INITiate and FETCh commands. It aborts any
current triggering sequence and sets the trigger state to idle. It then initiates a new active
measurement (i.e., begins the collection of new data). When the measurement is complete, it
returns the result. These commands will not switch to another measurement.
To get the current measurement data, use the FETCh command.
:READ:DEMod:CONStln?
Title: Read Constellation
Description: Triggers a new Constellation measurement and returns the results:
Related Command: :FETCh:DEMod:CONStln?
:READ:DEMod:EVSCarrier?
Title: Read EVM vs. Sub Carrier
Description: Triggers a new EVM vs. Sub Carrier measurement and returns the
Related Command: :FETCh:DEMod:EVSCarrier?
S412E PM
EVM (rms),
EVM (pk), RCE (rms), RCE (pk), Carrier Frequency, Freq Error, Freq
Error, and the Base Station ID. The Constellation measurement must
be the active measurement (specified by :CONFigure:DEMod CONStln).
The current measurement can be queried using the command
:CONFigure?
Data is returned as 8 comma-delimited values: EVM (rms) in %, EVM
(pk) in %, RCE (rms) in dB, RCE (pk) in dB, Carrier Frequency in MHz,
Freq Error in MHz, Freq Error in ppm, and the Base Station ID.
:CONFigure:DEMod CONStln
results: EVM (rms), EVM (pk), RCE (rms), RCE (pk), Carrier
Frequency, Freq Error, Freq Error, and the Base Station ID. The EVM
vs. Sub Carrier measurement must be the active measurement
(specified by :CONFigure:DEMod EVSCarrier). The current
measurement can be queried using the command :CONFigure?
Data is returned as 8 comma-delimited values: EVM (rms) in %, EVM
(pk) in %,
RCE (rms) in dB, RCE (pk) in dB, Carrier Frequency in MHz, Freq
Error in MHz, Freq Error in ppm, and the Base Station ID.
:CONFigure:DEMod EVSCarrier
PN: 10580-00319 Rev. N
7-9 :READ Subsystem
7-19