Sense] Subsystem - Anritsu LMR Master S412E Programming Manual

LTE Commands
9-11

[:SENSe] Subsystem

The commands in this subsystem relate to device-specific parameters, not signal-oriented
parameters.
[:SENSe]:4TAE:ACTive OFF|ON
[:SENSe]:4TAE:ACTive?
Title: Time Alignment Error (4x4 MIMO configuration)
Description: Sets the state of the TAE measurement for OTA carrier aggregation. In
Parameter: OFF|ON
Parameter Type: <boolean>
Front Panel Access: Measurements, Over-the-Air, Carrier Aggregation, TAE
[:SENSe]:BANDWidth[:RESolution] 1.4|3|5|10
[:SENSe]:BANDWidth[:RESolution]?
Title: Bandwidth Resolution
Description: Sets the channel bandwidth.
Parameter: 1.4|3|5|10
Parameter Type: <char>
Default Value: The default bandwidth is 10 MHz.
Front Panel Access: Setup, BW
[:SENSe]:CC{1|2|3|4|5}:ACTive OFF|ON
[:SENSe]:CC{1|2|3|4|5}:ACTive?
Title: Active Component Carrier
Description: Sets the specified Component Carrier (CC) to be on or off.
Parameter: OFF|ON|0|1
Parameter Type: <boolean>
Front Panel Access: Measurements, Over-the-Air, Carrier Aggregation, CC#, CC#
[:SENSe]:CC{1|2|3|4|5}:BANDWidth 1.4|3|5|10
[:SENSe]:CC{1|2|3|4|5}:BANDWidth?
Title: Component Carrier Bandwidth
Description: Sets the channel bandwidth of the specified Component Carrier (CC).
Parameter: 1.4|3|5|10
Front Panel Access: Measurements, Over-the-Air, Carrier Aggregation, CC#, CC#, BW
S412E PM
2x2 MIMO, use the command [:SENSe]:TAE:ACTive.
PN: 10580-00319 Rev. N
9-11 [:SENSe] Subsystem
9-21