Anritsu LMR Master S412E Programming Manual page 129

An integrated, handheld multi-function land mobile radio test tool

Hide thumbs Also See for LMR Master S412E:

Table of Contents

VNA Commands

Related Command: :CALCulate:LIMit:TYPe

Front Panel Access: Shift 6 (Limit), Limit Edit, Limit X

:CALCulate:LIMit:Y <y-parameter>

:CALCulate:LIMit:Y?

Description: Sets the location of the active limit line on the y-axis at the given value.

Cmd Parameter: <NRf> <y-parameter> (depends on display type)

Query Response: <NR3> <y-parameter> (depends on display type)

Default Units: Current active trace y-axis unit

Related Command: :CALCulate:LIMit:TYPe

Front Panel Access: Shift 6 (Limit), Limit Edit, Amplitude

OR to 500 MHz:

:CALCulate:LIMit:X 500MHz

To move the active limit to 5 Feet (active trace in distance domain with

current distance unit in feet):

:CALCulate:LIMit:X 5FT

OR to 4 Meter

:CALCulate:LIMit:X 4M

:CALCulate:LIMit:X 4

:CALCulate:LIMit:Y

This moves the entire limit and moves the current active limit point by

the given value. Sending this command will change the Move Limit on

the front panel to Limit if it is currently set to Point. The

<y-parameter> is defined in the current y-axis. If no unit is specified

with the <y-parameter> then the default unit will be used. The query

version of the command returns the location of the active limit point on

the y-axis. If an error occurs, such as limit not ON, the query version of

the command returns an error code of –400. Limit line must be on for

the command to be valid. Use :CALCulate:LIMit:TYPE to set the

currently active limit line.

:CALCulate:LIMit:X

PN: 10580-00319 Rev. N

5-2 :CALCulate Subsystem