Mmemory Subsystem - Anritsu LMR Master S412E Programming Manual

TETRA Commands

17-8 :MMEMory Subsystem

The Mass Memory subsystem contains functions that provide access to the instrument's
setup and data storage.
:MMEMory:LOAD:STATe <integer>,<filename>
Description: Recalls a previously stored instrument setup in the current save
Cmd Parameters: <integer>,<filename>
Query Parameters: NA
Range: NA
Default Value: NA
Default Unit: NA
Example: To recall a setup file:
Front Panel Access: Shift 7 (File), Recall
:MMEMory:LOAD:TRACe <integer>,<filename>
Description: The instrument must be in the mode of the saved trace in order to recall
S412E PM
location.
The setup file to be loaded is specified by <filename>. <filename>
should be enclosed in either single quotes (' ') or double quotes (" ") and
should contain a file extension ".stp". Use the command MMEMory:MSIS
to set the current save location. The <integer> parameter is not
currently used, but it must be sent. Send a 1.
:MMEMory:LOAD:STATe 1,"xxx.stp"
that trace. Use :INSTrument:SELect or :INSTrument:NSELect to
set the mode.
Recalls a previously stored measurement trace from the current save
location. The saved measurement trace to be loaded is specified by
<filename>. <filename> should be enclosed in either single quotes
(' ') or double quotes (" ") and should contain a file extension. Note that
the trace specified by <filename> should be available at the current
save location. Use the command MMEMory:MSIS to set the current save
location. The <integer> parameter is not currently used, but it must
be sent. Send a 1.
After recalling the data file, the unit is put into HOLD mode. Setting
the unit back to RUN mode will clear the recalled data, but keep the
recalled setup.
PN: 10580-00319 Rev. N
17-8 :MMEMory Subsystem
17-15