Anritsu LMR Master S412E Programming Manual page 60

4-2 :CALCulate Subsystem
:CALCulate:MARKer{1|2|3|4|5|6}:MAXimum:NEXT
Title: Marker (Maximum) Next
Description: Moves the specified marker to the next highest peak anywhere in the
Related Command: :CALCulate:MARKer{1|2|3|4|5|6}:MAXimum:LEFT
Front Panel Access: N/A
:CALCulate:MARKer{1|2|3|4|5|6}:NOISe[:STATe] OFF|ON|0|1
:CALCulate:MARKer{1|2|3|4|5|6}:NOISe[:STATe]?
Title: Marker Noise
Description: Turns the marker noise on or off for the specified reference marker.
Parameter: OFF|ON|0|1
Parameter Type: <boolean>
Default Value: OFF
Example: To set reference marker #3 as noise marker:
Front Panel Access: Marker, More, Marker Noise
4-18
trace that is lower than the current marker. If the specified marker is
not on, the command turns the marker on and sets it to the second
highest peak in the trace. The command uses the existing peak
threshold values to determine the peak value.
:CALCulate:MARKer{1|2|3|4|5|6}:MAXimum:RIGHt
Note that if counter marker is set to on when setting marker noise to on,
then counter marker is set to off. This command is not valid in zero
span.
:CALCulate:MARKer3:NOISe ON
:CALCulate:MARKer3:NOISe 1
PN: 10580-00319 Rev. N
Spectrum Analyzer Commands
S412E PM