Anritsu LMR Master S412E Programming Manual page 167

VNA Commands
Table 5-3. Trace Header Parameters (Sheet 6 of 8)
Parameter Name
TRACE_x_IMAG_Z_RESOLUTION
TRACE_x_IMAG_Z_REFERENCE
TRACE_x_IMAG_Z_REFERENCE_LINE
TRACE_x_START_FREQ
TRACE_x_STOP_FREQ
TRACE_x_CENTER_FREQ
TRACE_x_SPAN
TRACE_x_START_DIST
TRACE_x_STOP_DIST
TRACE_x_SMOOTHING_PERCENT
TRACE_x_WINDOWING
TRACE_x_GD_APERTURE
TRACE_x_DSP_DATA_POINTS
TRACE_x_LOG_MAG_RESOLUTION
TRACE_x_LOG_MAG_REFERENCE
TRACE_x_LOG_MAG_REFERENCE_LINE Log Mag Reference Line, where x is the trace
S412E PM
Imaginary Impedance resolution, where x is the
trace number. Returned value is 1000 times the
resolution value.
Imaginary Impedance Reference value, where x
is the trace number. Returned value is 1000 times
the reference value.
Imaginary Impedance Refernece line, where x is
the trace number.
Start freq, where x is the trace number. Returns in
units of megahertz.
Stop frequency, where x is the trace number.
Returns in units of megahertz.
Center frequency, where x is the trace number.
Returns in units of megahertz.
Frequency span, where x is the trace number.
Returns in units of megahertz.
Start distance, where x is the trace number.
Depending on the given distance unit, value is
returned in units of either microfeet or
micrometer.
Stop distance, where x is the trace number.
Depending on the given distance unit, value is
returned in units of either microfeet or
micrometer.
Currently not used.
Windowing, where x is the trace number.
Available windowing settings are:
Rectangular = 0, Nominal Side Lobe = 1,
Low Side Lobe = 2, Minimum Side Lobe = 3
Group Delay Aperture, where x is the trace
number.
Number of data points, where x is the trace
number.
Log Mag Resolution, where x is the trace number.
Returned value is in dB.
Log Mag Reference value, where x is the trace
number. Returned value is in dB.
number.
PN: 10580-00319 Rev. N
5-10 :Trace Subsystem
Description
5-59