Anritsu LMR Master S412E Programming Manual page 625

TETRA Commands
:SOURce:DM:PATTern:LIST?
Description: Retrieves a list of signal generator pattern names and the index number
Cmd Parameters: NA
Query Parameters: NA
Range: NA
Default Value: NA
Default Unit: NA
Example: To retrieve the signal generator pattern list:
Front Panel Access: Setup, Tx Pattern
:SOURce:FREQuency:CENTer <value>
:SOURce:FREQuency:CENTer?
Description: Sets the signal generator center frequency. Please note that setting the
Cmd Parameters: <value>
Query Parameters: NA
Range: 500000 Hz to 1600000000 Hz
Default Value: 800000000 Hz
Default Unit: Hz
Example: To set the signal generator center frequency to 145 MHz:
Front Panel Access: Frequency, Tx Freq
S412E PM
that is used to set the pattern. The pattern names match the names of
the pattern list that pops up when the Tx Pattern button is pushed and
the index number is the position of the pattern on that list. The
command returns a list with the following format and patterns:
0: tetra_bs_idle_unallocPCH
1: tetra_bs_busy_allocPCH
2: cw
3: am_1khz_audio
4: fm_1khz_audio
:SOURce:DM:PATTern:LIST?
center frequency will restart the sweep. The query returns the current
signal generator frequency in Hz.
:SOURce:FREQuency:CENTer 145000000
PN: 10580-00319 Rev. N
17-10 :SOURce Subsystem
17-21