Anritsu LMR Master S412E Programming Manual page 252

8-9 :READ Subsystem
Related Command: :FETCh:DEMod:EVSYmbol?
:READ:DEMod:SFLatness?
Title: Read Spectral Flatness
Description: Triggers a new Spectral Flatness measurement and returns the
Related Command: :FETCh:DEMod:SFLatness?
:READ:PFail?
Title: Read PASS/FAIL
Description: Triggers a new PASS/FAIL measurement and returns the results. It is a
Related Command: :FETCh:PFail?
Front Panel Access: Measurements, Pass/Fail Mode
:READ:RF:ACPR?
Title: Read Adjacent Channel Power Ratio
Description: Triggers a new Adjacent Channel Power Ratio measurement and
8-20
Data is returned as 8 comma-delimited values: EVM (rms) in %, EVM
(pk) in %, RCE (rms) in dB, RCE (pk) in dB, Carrier Frequency in MHz,
Freq Error in MHz, Freq Error in ppm, and the Base Station ID.
:CONFigure:DEMod EVSYmbol
absolute delta of the power between adjacent sub carriers in dB. The
Spectral Flatness measurement must be the active measurement
(specified by :CONFigure:DEMod SFLatness). The current
measurement can be queried using the command :CONFigure?
:CONFigure:DEMod SFLatness
combination of the commands :ABORT; :INITiate; :FETCh:PFail? The
PASS/FAIL measurement must be active. The current measurement
can be queried using :CONFigure?
:CONFigure PFail
:MEASure:PFail?
returns the results: Power levels for each channel (both absolute and
relative). It is a combination of the commands :ABORT; :INITiate;
:FETCh:RF:ACPR? The ACPR measurement must be the active
measurement (specified by :CONFigure:RF ACPR). The current
measurement can be queried using :CONFigure?
PN: 10580-00319 Rev. N
Mobile WiMAX Commands
S412E PM