Anritsu LMR Master S412E Programming Manual page 412

An integrated, handheld multi-function land mobile radio test tool

Hide thumbs Also See for LMR Master S412E:

Table of Contents

12-13 [:SENSe] Subsystem

[:SENSe]:DM:SQUelch <value>

[:SENSe]:DM:SQUelch?

Description: Sets the squelch power level. The squelch is only applied to the

Cmd Parameters: <value>

Query Parameters: NA

Range: 0 dBm to -120 dBm or 1 fW to 1000000000000 fW

Default Value: -100 dBm or 100 fW or 2.24 μV

Default Unit: dBm or fW or fV

Example: To set the squelch to -10 dBm:

Front Panel Access: Setup, Squelch Lvl

NXDN Analyzer Summary window on the front panel and will blank

out (--) all summary measurements except for Received Pwr when the

received power level is lower than the squelch power setting.

FETCh:SIGAnalyzer?, READ:SIGAnalyzer?, and

MEASure:SIGAnalyzer? will always return all numerical values.

The query will be returned in the units (dBm, Watts, or Volts) selected

through the Rx Units button using the front panel or with the

command: UNIT:POWer:RX. If the Rx Units has been set to dBm, the

squelch setting is returned in dBm. If the unit is set to Watts, the

squelch setting is returned in fW. If the unit is set to Volts, the squelch

setting is returned in fV.

The set command is sent using the units selected with the Rx Units

button on the front panel or with the command: UNIT:POWer:RX. If the

Rx Units has been set to dBm, the squelch setting must be set in dBm.

If the unit is set to watts, the squelch setting must be set in fW. If the

unit is set to Volts, the squelch setting must be set in fV.

or 223.6 mV to 223.61 nV

:DM:SQUelch -10

PN: 10580-00319 Rev. N

NXDN Commands