Anritsu LMR Master S412E Programming Manual page 432

13-8 :MMEMory Subsystem
:MMEMory:LOAD:TRACe <integer>,<filename>
Description: The instrument must be in the mode of the saved trace in order to recall
Cmd Parameters: <integer>,<filename>
Query Parameters: NA
Range: NA
Default Value: NA
Default Unit: NA
Example: To recall a measurement file:
Front Panel Access: Shift 7 (File), Recall Measurement
13-16
that trace. Use :INSTrument:SELect or :INSTrument:NSELect to
set the mode.
Recalls a previously stored measurement trace from the current save
location. The saved measurement trace to be loaded is specified by
<filename>. <filename> should be enclosed in either single
quotes (' ') or double quotes (" ") and should contain a file extension.
Note that the trace specified by <filename> should be available at the
current save location. Use the command MMEMory:MSIS to set the
current save location. The <integer> parameter is not currently used,
but it must be sent. Send a 1.
After recalling the data file, the unit is put into HOLD mode. Setting
the unit back to RUN mode will clear the recalled data, but keep the
recalled setup.
File name extensions:
".spa" for SPA measurement
".mna" for VNA and VVM measurements
".hipm" for HiPM measurements
".pm" for PM measurements
".cwsg" for CWSG measurements
".afp" for AM/FM/PM measurements
".ia" for Interference Analysis measurements
".cs" for Channel Scanner measurements
".wmxd" for WiMAX
".wmxe" for Mobile WiMAX
".lte" for LTE measurements
".p25" for P25 measurements
".p252" for P25p2 measurements
".nxdn" for NXDN measurements
".dpmr" for dPMR measurements
".dmr2" for DMR 2 measurements
".ptc" for PTC measurements
".tetra" for TETRA measurements
".nbfm" for NBFM measurements
:MMEMory:LOAD:TRACe 1,"xxx.dpmr"
PN: 10580-00319 Rev. N
dPMR Commands
S412E PM