Anritsu LMR Master S412E Programming Manual page 54

4-2 :CALCulate Subsystem
:CALCulate:LIMit:Y <y-parameter>
Title: Limit Line Y Value
Description: Sets the location of the active limit line on the y-axis at the specified
Parameter: <y-parameter>
Default Unit: Current y-axis unit.
Example: To move limit and set the active point to 5 dbm:
Front Panel Access: Shift-6 (Limit), Limit Edit, Amplitude
:CALCulate:LIMit[:SET]:DEFault
Title: Set Default Limit
Description: Deletes all limit points for the currently active limit line and sets the
Example: To set the default limit line:
Front Panel Access: Shift-6 (Limit), Set Default Limit
4-12
location. This moves the entire limit and moves the current active limit
point by the given value. <y-parameter> is defined in the current y-axis.
Note that this will change the Move Limit on the front panel to Limit if
it is currently set to Point. Use :CALCulate:LIMit:TYPe to set the
currently active limit line.
:CALCulate:LIMit:Y 5
(If y-axis unit is dBm)
:CALCulate:LIMit:Y 5dBm
default limit line value. Note that this command will turn on the
currently selected limit line if it is not already on. The current selected
limit line can be modified by using the command
:CALCulate:LIMit:TYPe.
:CALCulate:LIMit[:SET]:DEFault
:CALCulate:LIMit:DEFault
PN: 10580-00319 Rev. N
Spectrum Analyzer Commands
S412E PM