Anritsu LMR Master S412E Programming Manual page 100

4-14 [:SENSe] Subsystem
[:SENSe]:CORRection:IMPedance[:INPut]:OFFSet <rel ampl>
[:SENSe]:CORRection:IMPedance[:INPut]:OFFSet?
Title: Other Input Impedance Loss
Description: Sets the value that is used for amplitude correction when the value set
Parameter: <rel ampl>
Default Value: 0
Default Unit: dB
Range: 0 dB to 100 dB
Related Command: :CORRection:IMPedance[:INPut][:MAGNitude]
Front Panel Access: Shift-8 (System), Application Options, Impedance
[:SENSe]:CORRection:IMPedance[:INPut][:MAGNitude] <integer>
[:SENSe]:CORRection:IMPedance[:INPut][:MAGNitude]?
Title: Input Impedance
Description: Sets the input impedance that is used for amplitude correction and
Parameter: <integer>
Parameter Type: <integer>
Default Value: 50
Range: 50, 75 all other values are treated as described above
Related Command: :BANDwidth|BWIDth:VIDeo:RATio
Front Panel Access: Shift-8 (System), Application Options, Impedance
4-58
by [:SENSe]:CORRection:IMPedance[:INPut][:MAGNitude] is
something other than 50 or 75. This value is not applied if the
impedance is set to either 50 or 75.
conversion between units (dBm vs. dBV vs. Volts, etc.). If the value of
<integer> is 50 no correction is performed. If the value of <integer> is 75
correction is done based on Anritsu adapter 12N50-75B.
PN: 10580-00319 Rev. N
Spectrum Analyzer Commands
S412E PM