Anritsu LMR Master S412E Programming Manual page 13

General Information
other. A single LAN that is not connected to other LANs requires a default gateway
setting of 0.0.0.0. If you have a gateway, then the default gateway would be set to the
appropriate value of your gateway
• Ethernet Address: An Ethernet address is a unique 48-bit value that identifies a
network interface card to the rest of the network. Every network card has a unique
ethernet address (MAC address) permanently stored into its memory.
Interface between the LMR Master and other devices on the network is via a category five
(CAT-5) interface cable connected to a network. This cable uses four twisted pairs of insulated
copper wires terminated into an RJ45 connector. CAT-5 cabling is capable of supporting
frequencies up to 100 MHz and data transfer speeds up to 1 Gbps, which accommodates
1000Base-T, 100Base-T, and 10Base-T networks. CAT-5 cables are based on the EIA/TIA 568
Commercial Building Telecommunications Wiring Standard developed by the Electronics
Industries Association. A pinout diagram is shown in
Table 1-1. 8-pin Ethernet RJ45 Connector Pinout Diagram
Pin Name
1 TX+
2 TX–
3 RX+
4
5
6 RX–
7
8
TCP/IP connectivity requires setting up the parameters described at the beginning of this
section. The following is a brief overview of how to set up a general LAN connection on the
S412E.
You may need to consult your network documentation or network administrator for
Note
assistance in configuring your network setup.
S412E PM
Description
Transmit data (> +3 volts)
Transmit data (< –3 volts)
Receive data (> +3 volts)
– Not used (common mode termination)
– Not used (common mode termination)
Receive data (< –3 volts)
– Not used (common mode termination)
– Not used (common mode termination)
PN: 10580-00319 Rev. N
1-4 Remote Programming Setup and Interface
Table
8 7 6 5 4 3 2 1
1-1.
Wire Color
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
1-3