Anritsu LMR Master S412E Programming Manual page 486

14-11 :TRACe Subsystem
14-11 :TRACe Subsystem
This subsystem contains commands related to the transfer of trace data to and from the
instrument.
:TRACe:PREamble?
Description: Returns trace header information. Use the commands in the
Cmd Parameters: NA
Query Parameters: NA
Range: NA
Default Value: NA
Default Unit: NA
Example: To get the trace preamble:
Front Panel Access: NA
Table 14-1. Returned Parameter Values in Trace Preamble (Sheet 1 of 7)
Parameter Name
SN
UNIT_NAME
TYPE
DATE
APP_NAME
APP_VER
GPS_FIX_AVAIL
GPS_FIX_TIME
14-30
MMEMory subsystem to store and recall traces from the instrument
memory. The response begins with an ASCII header. The header
specifies the number of following bytes. It appears in the format #AX,
where A is the number of digits in X, and X is the number of bytes that
follow the header.
Parameters are returned in comma-delimited ASCII format. Each
parameter is returned as "NAME=VALUE[UNITS]". Note that the
parameters that are returned depend on the firmware version and that
this document may not cover all parameter values that are returned by
the command. Refer to
:TRACe:PREamble?
PN: 10580-00319 Rev. N
Table 14-1.
Instrument serial number.
Instrument name.
The data type (Setup or data).
Trace date and time.
Application name.
Application firmware (FW) version.
Status of GPS lock. Please note that none of the GPS
information will show if there is no GPS lock.
Current UTC time shown in hours, minutes, seconds.
Even if a file has been recalled, the current UTC time
will be returned.
DMR 2 Commands
Description
S412E PM