Anritsu LMR Master S412E Programming Manual page 166

5-10 :Trace Subsystem
Table 5-3. Trace Header Parameters (Sheet 5 of 8)
Parameter Name
TRACE_SMOOTHING_PERCENT
SMOOTHING_PERCENT
CURRENT_LIMIT
LIMIT_STATE
LIMIT_ALARM
LIMIT_MESSAGE
CURRENT_TEMPERATURE
TRACE_x_LP_MODE
TRACE_x_LP_RESPONSE_TYPE
TRACE_x_LP_PHASOR_IMPULSE
TRACE_x_POLAR_RESOLUTION
TRACE_x_POLAR_REFERENCE
TRACE_x_POLAR_REFERENCE_LINE
TRACE_x_LOG_POLAR_RESOLUTION
TRACE_x_LOG_POLAR_REFERENCE
TRACE_x_LOG_POLAR_REFERENCE_LI
NE
TRACE_x_REAL_Z_RESOLUTION
TRACE_x_REAL_Z_REFERENCE
TRACE_x_REAL_Z_REFERENCE_LINE
5-58
Trace smoothing percent. This uses a bit mask
shift, where the bit shift mask is defined as:
PERC_SMOOTHING_BIT_SHIFT 8
PERC_SMOOTHING_BIT_MASK 0xFF
Current active trace smoothing percent.
The limit type (upper/lower) for the active trace.
Upper = 0 and Lower = 1
The limit state (on/off) for the active trace.
On = 0, Off = 1
The limit alarm (on/off) for the active trace.
On = 0, Off = 1
Limit Pass Fail Message (on/off) for the active
trace. On = 0, Off = 1.
The current temperature. Valid only with a cal.
To get the temperature in Celsius divide the
result by 4.
Currently not used.
Currently not used.
Currently not used.
Linear Polar Resolution, where x is the trace
number. Returned value is 1000 times the
resolution value
Linear Polar Reference value, where x is the
trace number. Returned value is 1000 times the
reference value
Currently not used
Log Polar Resolution, where x is the trace
number. Returned value is in dB.
Log Polar Reference value, where x is the trace
number. Returned value is in dB.
Currently not used
Real Impedance resolution, where x is the trace
number. Returned value is 1000 times the
resolution value.
Real Impedance Reference value, where x is the
trace number. Returned value is 1000 times the
reference value.
Real Impedance Reference line, where x is the
trace number.
PN: 10580-00319 Rev. N
VNA Commands
Description
S412E PM