Anritsu LMR Master S412E Programming Manual page 266

9-3 :CONFigure Subsystem
:CONFigure:DEMod
SUMMary|CONStln|CCPGraph|CCPTable|TIMEalign
Title: Select the Modulation Measurement
Description: Sets measurement to one of the Modulation screens. This can be one of:
Parameter: SUMMary|CONStln|CCPGraph|CCPTable|TIMEalign
Parameter Type: <char>
Front Panel Access: Measurements, Modulation, (Constellation, Control Channel Power, Tx
:CONFigure:OTA SCANner|TXTEst|MAPping|CAGGregation
Title: Configure Over-the-Air Measurement
Description: Sets the measurement to one of the Over-the-Air screens. This can be
Parameter: SCANner|TXTEst|MAPping|CAGGregation
Parameter Type: <char>
Front Panel Access: Measurements, Over-the-Air, (Scanner, Tx Test, Mapping, Carrier
9-6
SUMMary: Modulation Summary view
CONStln: Modulation Constellation diagram
CCPGraph: Control Channel Power - Bar-graph view
CCPTable: Control Channel Power - Table view
TIMEalign: Tx Time Alignment
It disables any other active measurements. None of the instrument
parameters are changed by the execution of this command. Sets the
instrument to single sweep mode (:INITiate:CONTinuous OFF).
Measurement settings can be modified by using the [:SENSe]
commands before initiating a measurement.
Time Alignment, Modulation Summary). If Control Channel Power is
selected, press Control Channel Power again, then press Display Mode
to select Bar Graph or Table.
one of:
SCANner: Scanner measurement view
TXTEst: Tx Test measurement view
MAPping: Coverage Mapping measurement view
CAGGregation: Carrier Aggregation measurement view
Aggregation)
PN: 10580-00319 Rev. N
LTE Commands
S412E PM