Anritsu LMR Master S412E Programming Manual page 509

PTC Commands
:DISPlay[:WINDow]:TRACe:Y[:SCALe]:RLEVel <value>
:DISPlay[:WINDow]:TRACe:Y[:SCALe]:RLEVel?
Description: Sets the reference level scale value for the y-axis. In the PTC Analyzer
Turning auto range on will automatically adjust the reference level. If auto range is
on and this command is sent, the reference level will be set to the value until the
Note
next sweep. If auto range is off, the unit will keep the value until either auto range is
turned back on, the reference level is changed, or a preset is activated.
Cmd Parameters: <value>
Query Parameters: NA
Range: -300 dBm to 20 dBm
Default Unit: dBm
Example: To set the reference level to -40:
Front Panel Access: Amplitude, Ref Lvl
:DISPlay[:WINDow]:TRACe:FORMat:COVerage <mapping type>
:DISPlay[:WINDow]:TRACe:FORMat:COVerage?
Description: Defines the mapping type. <mapping type> is the type of data that is
Cmd Parameters: <mapping type>
Query Parameters: NA
Range: RSSI|BER|MODFid
Default Value: RSSI
Default Unit: NA
Example: To set mapping type to Mod Fid:
Related Command: :CONFigure:COVerage
Front Panel Access: Measurement, PTC Coverage, Mapping Type
S412E PM
measurement, this value corresponds to the reference level on the
spectrum graph type.
:DISPlay:TRACe:Y:RLEVel -40
being mapped. Note that RSSI, BER, and Mod Fid data will be stored,
but only the selected mapping type will be used in the comparisons to
determine the color of the points on the map. Mapping type must be one
of the following values:
RSSI|BER|MODFid
The query version of this command returns "RSSI" if the mapping type
is set to RSSI, "BER" if set to BER, and "MODF" if set to Mod Fid.
Please note that this command only works when the current
measurement is set to PTC Coverage. Refer to the Related Command
below.
:DISPlay:TRACe:FORMat:COVerage MODFid
PN: 10580-00319 Rev. N
15-3 :DISPlay Subsystem
15-5