Anritsu LMR Master S412E Programming Manual page 50

4-2 :CALCulate Subsystem
:CALCulate:LIMit:POINt:X <x-parameter>
:CALCulate:LIMit:POINt:X?
Title: Limit Point X Value
Description: Sets the location of the active limit point on the x-axis at the specified
Parameter: <x-parameter>
Default Unit: Hz or for zero span in seconds
Example: To set the active point to 5 Hertz:
Front Panel Access: Shift-6 (Limit), Limit Edit, Frequency
:CALCulate:LIMit:POINt:Y <y-parameter>
:CALCulate:LIMit:POINt:Y?
Title: Limit Point Y Value
Description: Sets the location of the active limit point on the y-axis at the specified
Parameter: <y-parameter>
Default Unit: Current y-axis unit.
Example: To set the active point to 5 dBm:
Front Panel Access: Shift-6 (Limit), Limit Edit, Amplitude
:CALCulate:LIMit:POINt?
Title: Number of Limit Points
Description: Returns the number of points currently in the selected limit line. Use
Related Command: :CALCulate:LIMit:TYPe
4-8
location. <x-parameter> is defined in the current x-axis. Note that this
will change the Move Limit on the front panel to Point if it is currently
set to Limit. The query version of the command returns the location of
the active limit point on the x-axis. Use :CALCulate:LIMit:TYPe to set
the currently active limit line.
:CALCulate:LIMit:POINt:X 5
:CALCulate:LIMit:POINt:X 5Hz
To set the active point to 500 MHz:
:CALCulate:LIMIt:POINt:X 500MHz
location. <y-parameter> is defined in the current y-axis. Note that this
will change the Move Limit on the front panel to Point if it is currently
set to Limit. The query version of the command returns the location of
the active limit point on the y-axis. Use :CALCulate:LIMit:TYPe to set
the currently active limit line.
:CALCulate:LIMit:POINt:Y 5
(If y-axis unit is dBm)
:CALCulate:LIMit:POINt:Y 5dBm
:CALCulate:LIMit:TYPe to set the currently active limit line.
PN: 10580-00319 Rev. N
Spectrum Analyzer Commands
S412E PM