Configure Subsystem - Anritsu LMR Master S412E Programming Manual

Spectrum Analyzer Commands
4-3

:CONFigure Subsystem

This set of commands prepares the instrument for the selected measurement. It disables any
currently-enabled measurements and activates the specified measurement. It sets the
instrument to single sweep mode, waiting for an :INITiate command. It will not initiate the
taking of a measurement.
Current instrument settings may be changed to default values. These changes are identified
with their respective measurement commands.
:CONFigure:ACPower
Title: Configure Adjacent Channel Power Ratio
Description: Configures the default adjacent channel power ratio measurement.
Related Command: :ACPower:STATe
:CONFigure:CHPower
Title: Configure Channel Power
Description: Configures the default channel power measurement. Disables any other
Related Command: :CHPower:STATe
S412E PM
Disables any other active one-button measurements, including channel
power, occupied bandwidth, AM/FM demodulation and C/I. Sets the
main channel bandwidth equal to the span. Sets the adjacent channel
bandwidth and channel spacing equal to the main channel bandwidth.
Sets the detection method to RMS. Sets the instrument to single sweep
mode (:INITiate:CONTinuous OFF). Measurement settings can be
modified by using the [:SENSe]:ACPower commands before initiating a
sweep.
:ACPower:BANDwidth|BWIDth:MAIN
:ACPower:BANDwidth|BWIDth:ADJacent
:ACPower:BANDwidth|BWIDth:SPACing
active one-button measurements, including ACPR, occupied bandwidth,
AM/FM demodulation and C/I. Sets the integration bandwidth equal to
the span. Sets the detection method to RMS. Sets the instrument to
single sweep mode (:INITiate:CONTinuous OFF). Measurement
settings can be modified by using the [:SENSe]:CHPower commands
before initiating a sweep. Note that this measurement is not valid in
zero span.
:SENSe:CHPower:BANDwidth|BWIDth:INTegration
PN: 10580-00319 Rev. N
4-3 :CONFigure Subsystem
4-21