Anritsu LMR Master S412E Programming Manual page 119

VNA Commands
:CALCulate:LIMit:POINt:DELete
Description: Deletes the active trace active limit point. After deletion, the point that
Cmd Parameter: NA
Query Response: NA (no query)
Example: To delete the currently active limit point
Related Command: :CALCulate:LIMit:POINt:ADD
Front Panel Access: Shift 6 (Limit), Limit Edit, Delete Point
:CALCulate:LIMit:POINt:LEFT
Description: Sets the limit point immediately to the left of the active limit point as
Cmd Parameter: NA
Query Response: NA (no query)
Example: To select the point to the left of the active point
Related Command: :CALCulate:LIMit:POINt:RIGHt
Front Panel Access: Shift 6 (Limit), Limit Edit, Next Point Left
:CALCulate:LIMit:POINt:RIGHt
Description: Sets the limit point immediately to the right of the active limit point as
Cmd Parameter: NA
Query Response: NA (no query)
Example: To select the point to the right of the active point:
Related Command: :CALCulate:LIMit:POINt:LEFT
Front Panel Access: Shift 6 (Limit), Limit Edit, Next Point Right
S412E PM
is immediately to the left of the point that was deleted becomes the
active point. Note that deletion is valid only if 2 or more limit points
exist. Use :CALCulate:LIMit:TYPE to set the currently active limit
line.
:CALCulate:LIMit:POINt:DELete
the active point. This makes it active for editing or deleting. Use
:CALCulate:LIMit:TYPE to set the currently active limit line.
:CALCulate:LIMit:POINt:LEFT
the active point. This makes it active for editing or deleting. Use
:CALCulate:LIMit:TYPE to set the currently active limit line.
:CALCulate:LIMit:POINt:RIGHt
PN: 10580-00319 Rev. N
5-2 :CALCulate Subsystem
5-11