Chapter 6-Vector Voltmeter Commands; Introduction; Fetch Subsystem - Anritsu LMR Master S412E Programming Manual

Chapter 6 — Vector Voltmeter
Commands
6-1

Introduction

This chapter describes commands for Vector Voltmeter mode. Only the commands that are
listed in this chapter and in
Voltmeter mode. Using commands from other modes may produce unexpected results.
Refer to Chapter 5
[:SENSe]:CALibration
[:SENSe]:CORRection
[:SENSe]:CORRection:CKIT
[:SENSe]:CORRection:CKIT:USER
[:SENSe]:CORRection:COLLect
6-2

:FETCh Subsystem

This subsystem contains commands to fetch the VVM data and relative data.
S412E PM
Chapter 3, "All Mode Commands"
for additional information on the following commands.
PN: 10580-00319 Rev. N
can be used in Vector
on page 5-66
on page 5-67
on page 5-69
on page 5-70
on page 5-71
6-1