[:Sense]:Application Subsystem - Anritsu LMR Master S412E Programming Manual

VNA Commands

[:SENSe]:APPLication Subsystem

This subsystem contains application specific commands.
[:SENSe]:APPLication:TST? NORMal|PWRon
Description: Executes an application self test and reports whether any errors were
Syntax: :APPLication:TST? NORMal|PWRon
Cmd Parameter: NA (query only)
Query Parameter: <char> NORMal|PWRon
Query Response: <NR1> <integer>
Front Panel Access: NA
[:SENSe]:APPLication:TST:RESult?
Description: Returns the application self test result of the previous call to the
Cmd Parameter: NA (query only)
Query Response: <block> (No units, NA)
Front Panel Access: NA
S412E PM
detected. A return value of "0" indicates that the test was completed
without detecting any error.
Two self test types can be specified. If no test type is specified, then the
test defaults to NORMal. The PWRon self test is a scaled-down version
of the normal self test that runs during the instrument power-on cycle.
application self test. The response begins with an ASCII header. The
header specifies the number of following bytes. It appears in the format
#AX<block data>, where A is the number of digits in X, and X is
the number of bytes that follow the header. The first information of the
<block data> contains the overall self test string ("PASSED" or
"FAILED") followed by a comma, and each self test result separated by
a comma. Each subset of the result is included in angle brackets, < >.
Note that an application self test command must be called prior to
calling this command in order for the result to be valid.
PN: 10580-00319 Rev. N
5-11 [:SENSe] Subsystem
5-65