Anritsu LMR Master S412E Programming Manual page 301

P25 Phase 1 Commands
:MEASure:SIGAnalyzer?
Description: Sets the active measurement to P25 Analyzer, triggers a new
Cmd Parameters: NA
Query Parameters: NA
Range: NA
Default Value: NA
Default Unit: NA
Example: To measure P25 Analyzer numerical data:
Front Panel Access: NA
S412E PM
measurement and returns the numerical results. It is a combination of
the commands :CONFigure:SIGAnalyzer and :READ:SIGAnalyzer?
Data is returned as 7 comma-separated values in the following order
and format:
Received Power (dBm as float or Watts as long long int or Volts as
long long int)
Frequency Error (Hz as float)
Mod Fid (% as float)
BER (% as float)
Symbol Dev (Hz as float)
NAC (hex)
Symbol Rate Error (Hz as float)
If there is no valid measurement data, the instrument will return
"--,--,--,--,--,--,--".
The received power will be returned in the unit that is selected through
the Rx Units button on the front panel or with the command:
UNIT:POWer:RX. If the receiver unit has been set to dBm, the received
power is returned in dBm. If the unit is set to Watts, the received power
is returned in fW (10
is returned in fV (10
Note: The squelch setting :DM:SQUelch will blank out (--) all
summary measurements on the instrument display except for Received
Pwr when the received power level is lower than the squelch power
setting. The received power level is also affected by the Rx Power Offset
setting. The query command will still return values even if the
instrument display is blanked out.
:MEASure:SIGAnalyzer?
PN: 10580-00319 Rev. N
-15
W). If the unit is set to Volts, the received power
-15
V).
10-7 :MEASure Subsystem
10-15