Anritsu LMR Master S412E Programming Manual page 98

4-14 [:SENSe] Subsystem
[:SENSe]:BANDwidth|BWIDth[:RESolution] <freq>
[:SENSe]:BANDwidth|BWIDth[:RESolution]?
Title: Resolution Bandwidth
Description: Sets the resolution bandwidth. Note that using this command turns the
Parameter: <freq>
Default Value: 3 MHz
Default Unit: Hz
Range: 10 Hz to 3 MHz in a 1:3 sequence except for the MS2711E
Related Command: :BANDwidth|BWIDth[:RESolution]:AUTO
Front Panel Access: BW, RBW
[:SENSe]:BANDwidth|BWIDth[:RESolution]:AUTO OFF|ON|0|1
[:SENSe]:BANDwidth|BWIDth[:RESolution]:AUTO?
Title: Resolution Bandwidth Coupling
Description: Sets the state of the coupling of the resolution bandwidth to the
Parameter: OFF|ON|0|1
Parameter Type: <boolean>
Default Value: ON
Related Command: [:SENSE]:BANDwidth|BWIDth[:RESolution]:RATio
Front Panel Access: BW, Auto RBW
4-56
automatic resolution bandwidth setting OFF.
100 Hz to 3 MHz in a 1:3 sequence for the MS2711E
frequency span. Setting the value to ON or 1 will result in the resolution
bandwidth being coupled to the span. That is, when the span changes,
the resolution bandwidth changes. Setting the value to OFF or 0 will
result in the resolution bandwidth being un-coupled from the span.
That is, changing the span will not change the resolution bandwidth.
When this command is issued, the resolution bandwidth setting itself
will not change. The default value is ON. That is, sending
:SENS:BAND:RES:AUTO is equivalent to sending
:SENS:BAND:RES:AUTO ON.
PN: 10580-00319 Rev. N
Spectrum Analyzer Commands
S412E PM