Anritsu LMR Master S412E Programming Manual page 599

NBFM Commands
[:SENSe]:FREQuency:COUPling:OFFSet <value>
[:SENSe]:FREQuency:COUPling:OFFSet?
Description: Sets the frequency coupling offset. If frequency coupling is on, the
Cmd Parameters: <Value>
Query Parameters: NA
Range: -1000000000 Hz to 1000000000 Hz
Default Value: 0 Hz
Default Unit: Hz
Example: To set coupling offset to 200 MHz:
Front Panel Access: Frequency, Coupling Offset
[:SENSe]:FREQuency:SPAN 12.5|25|50
[:SENSe]:FREQuency:SPAN?
Description: Sets the span of the Spectrum display in NBFM Analyzer measurement
Cmd Parameters: 12.5|25|50
Query Parameters: NA
Range: 12.5|25|50
Default Value: 25
Default Unit: kHz
Example: To set the span to 50 kHz:
Front Panel Access: Frequency, Span
S412E PM
Tx frequency will automatically trail the Rx frequency by this amount.
Please note that the instrument will prevent any coupling offset setting
that will make the Tx frequency go beyond the min/max values.
The query returns the current coupling offset in Hz.
:FREQuency:COUPling:OFFSet 200000000
mode.
Note: Span value is set and returned in kHz.
:FREQuency:SPAN 50
PN: 10580-00319 Rev. N
16-13 [:SENSe] Subsystem
16-49