Syntax
Parameter
Query response
Example
See also
SCPI Commands
:SYSTem:COMMunicate:NETwork:PRINter:SET
:SYSTem:COMMunicate:NETwork:PRINter:SET
This command is one of the commands to register the network printer setup. To
register a printer setup, the following commands must be entered:
•
:SYSTem:COMMunicate:NETwork:PRINter:NET:NAME
•
:SYSTem:COMMunicate:NETwork:PRINter:NET:IPADdress
•
:SYSTem:COMMunicate:NETwork:PRINter:NET:TEXToption
•
:SYSTem:COMMunicate:NETwork:PRINter:NET:GRAPhoption
•
:SYSTem:COMMunicate:NETwork:PRINter:NET:TYPE
•
:SYSTem:COMMunicate:NETwork:PRINter:SET
You can register maximum 4 setups.
This command registers the network printer setup. The setup is stored in the internal
memory. Query returns the present setting.
:SYSTem:COMMunicate:NETwork:PRINter:SET NET1 | NET2 | NET3 | NET4
Parameter
Type
NET1
character
NET2
character
NET3
character
NET4
character
name, ipaddress, textoption, graphoption, type <newline><^END>
OUTPUT @Hp4155;":SYST:COMM:NET:PRIN:SET NET1"
OUTPUT @Hp4155;":SYST:COMM:NET:PRIN:SET? NET2"
ENTER @Hp4155;A$
:SYSTem:COMMunicate:NETwork:PRINter:DELete
5-314
Agilent 4155C/4156C SCPI Command Reference, Edition 1
Explanation
Specifies register 1 to store the setup.
Specifies register 2 to store the setup.
Specifies register 3 to store the setup.
Specifies register 4 to store the setup.