Page:measure[:Sweep]:Var1:Stop - Agilent Technologies 4155C Command Reference Manual

Query response
Example
Syntax
Parameter
Query response
Example
The polarity of step value is automatically determined by the relation between start
and stop values. So, for the step value you specify, only absolute value has meaning.
The polarity has no meaning.
step <newline><^END>
step is NR3 response data type.
OUTPUT @Hp4155;":PAGE:MEAS:VAR1:STEP 0.01"
OUTPUT @Hp4155;":PAGE:MEAS:VAR1:STEP?"
ENTER @Hp4155;A

:PAGE:MEASure[:SWEep]:VAR1:STOP

This command sets the sweep STOP value of VAR1.
At *RST, this value is 1 V.
:PAGE:MEASure [ :SWEep] :VAR1:STOP stop | MINimum | MAXimum
Parameter Type
stop numeric
stop <newline><^END>
stop is NR3 response data type.
OUTPUT @Hp4155;":PAGE:MEAS:VAR1:STOP 1"
OUTPUT @Hp4155;":PAGE:MEAS:VAR1:STOP MAX"
OUTPUT @Hp4155;":PAGE:MEAS:VAR1:STOP?"
ENTER @Hp4155;A
OUTPUT @Hp4155;":PAGE:MEAS:VAR1:STOP? MAX"
ENTER @Hp4155;A
Agilent 4155C/4156C SCPI Command Reference, Edition 1
:PAGE:MEASure[:SWEep]:VAR1:STOP
Explanation
-200 to 200 V or -1 to 1 A. The range of this value
depends on the unit type of VAR1.
SCPI Commands
5-231