Page:measure[:Sweep]:Var2:Compliance - Agilent Technologies 4155C Command Reference Manual

Syntax
Parameter
Query response
Example
Syntax
SCPI Commands

:PAGE:MEASure[:SWEep]:VAR2:COMPliance

:PAGE:MEASure[:SWEep]:VAR2:COMPliance
This command sets the COMPLIANCE value of VAR2.
You use this command only if there is an SMU whose function (FCTN) is VAR2.
If the unit type of VAR2 is VSU, this parameter is ignored.
At *RST, this value is 2 V.
:PAGE:MEASure [ :SWEep] :VAR2:COMPliance compliance | MINimum |
MAXimum
Parameter Type
compliance numeric
compliance <newline><^END>
compliance is NR3 response data type.
OUTPUT @Hp4155;":PAGE:MEAS:VAR2:COMP 2"
OUTPUT @Hp4155;":PAGE:MEAS:VAR2:COMP MAX"
OUTPUT @Hp4155;":PAGE:MEAS:VAR2:COMP?"
ENTER @Hp4155;A
OUTPUT @Hp4155;":PAGE:MEAS:VAR2:COMP? MAX"
ENTER @Hp4155;A
:PAGE:MEASure[:SWEep]:VAR2:PCOMpliance
This command sets the power compliance value of VAR2.
You use this command only if there is an SMU whose function (FCTN) is VAR2.
If the unit type of VAR2 is VSU, this parameter is ignored.
At *RST, this value is not defined, but the PCOMpliance:STATe is OFF.
:PAGE:MEASure [ :SWEep] :VAR2:PCOMpliance pcompliance | MINimum |
MAXimum
5-232 Agilent 4155C/4156C SCPI Command Reference, Edition 1
Explanation
-200 to 200 V or -1 to 1 A. The range of this value
depends on SMU type of VAR2.