Page:measure[:Sweep]:Vard:ratio - Agilent Technologies 4155C Command Reference Manual

Syntax
Parameter
Query response
Example
See also
SCPI Commands

:PAGE:MEASure[:SWEep]:VARD:RATio

:PAGE:MEASure[:SWEep]:VARD:RATio
This command sets the RATIO of VAR1'.
For each step of sweep, the output values of VAR1' are determined by the following
equation:
VAR1' = VAR1 ´ RATio + OFFSet
You use this command only if there is an SMU or VSU whose function (FCTN) is
VAR1'.
At *RST, this value is not defined.
:PAGE:MEASure [ :SWEep] :VARD:RATio ratio | MINimum | MAXimum
Parameter Type
ratio numeric
ratio <newline><^END>
ratio is NR3 response data type.
OUTPUT @Hp4155;":PAGE:MEAS:VARD:RATIO 0.1"
OUTPUT @Hp4155;":PAGE:MEAS:VARD:RATIO?"
ENTER @Hp4155;A
:PAGE:MEASure[:SWEep]:VARD:OFFSet
5-240 Agilent 4155C/4156C SCPI Command Reference, Edition 1
Explanation
ratio of VAR1'