Page:measure:sampling:period:auto - Agilent Technologies 4155C Command Reference Manual

Syntax
Parameter
Query response
Example
Syntax
Parameter
Query response
SCPI Commands

:PAGE:MEASure:SAMPling:PERiod:AUTO

:PAGE:MEASure:SAMPling:PERiod:AUTO
This command sets the TOTAL SAMPLING TIME for sampling measurement.
This command is available only for LINear mode.
If you set :PAGE:MEAS:SAMP:PER total_samp_time, then AUTO OFF is set.
:PAGE:MEASure:SAMPling:PERiod:AUTO OFF | ON | 0 | 1
Parameter Type
OFF or 0 boolean
ON or 1 boolean
0 | 1 <newline><^END>
OUTPUT @Hp4155;":PAGE:MEAS:SAMP:PER:AUTO ON"
OUTPUT @Hp4155;":PAGE:MEAS:SAMP:PER:AUTO?"
ENTER @Hp4155;A
:PAGE:MEASure:SAMPling:POINts
This command sets the NUMBER OF SAMPLES for sampling measurement.
:PAGE:MEASure:SAMPling:POINts no_of_samples | MINimum | MAXimum
Parameter
no_of_samples numeric
no_of_samples <newline><^END>
no_of_samples is NR1 response data type.
5-214 Agilent 4155C/4156C SCPI Command Reference, Edition 1
:PAGE:MEAS:SAMP:PER setting is effective.
auto (disables total sampling time stop event, and
enables the number of samples stop event.)
Type
1 to 10001
Explanation
Explanation