Page:measure:pgusetup:pulse:pgu<N>:Impedance - Agilent Technologies 4155C Command Reference Manual

Syntax
Parameter
Query response
Example
SCPI Commands
:PAGE:MEASure:PGUSetup:PULSe:PGU<n>:IMPedance
:PAGE:MEASure:PGUSetup:PULSe:PGU<n>:IMPeda
nce
This command sets the output IMPEDANCE of PGU<n>.
<n> is required to specify PGU number. Valid PGU numbers are PGU1 through
PGU2.
You use this command only if the specified PGU is set to VPULse mode (not V) by
the :PAGE:CHAN:PGU<n>:MODE command.
At *RST, this value is LOW.
:PAGE:MEASure:PGUSetup:PULSe:PGU<n>:IMPedance LOW | R50
Parameter Type
LOW character
R50 character
LOW | R50 <newline><^END>
OUTPUT @Hp4155;":PAGE:MEAS:PGUS:PULS:PGU1:IMP LOW"
OUTPUT @Hp4155;":PAGE:MEAS:PGUS:PULS:PGU1:IMP?"
ENTER @Hp4155;A$
5-182 Agilent 4155C/4156C SCPI Command Reference, Edition 1
Explanation
low impedance
50 W