Page:stress:setup:pcount - Agilent Technologies 4155C Command Reference Manual

Parameter
Query response
Example
Syntax
Parameter
Query response
Example
Parameter Type
DURation character
PCOunt character
DURation | PCOunt <newline><^END>
OUTPUT @Hp4155;":PAGE:STR:SET:MODE DUR"
OUTPUT @Hp4155;":PAGE:STR:SET:MODE?"
ENTER @Hp4155;A$

:PAGE:STRess:SETup:PCOunt

This command sets the stress time by the number of output pulses.
If :SETup:MODE is DURation, this parameter is not used.
:PAGE:STRess:SETup:PCOunt pcount | MINimum | MAXimum
Parameter Type
pcount numeric
pcount <newline><^END>
pcount is NR1 response data type.
OUTPUT @Hp4155;":PAGE:STR:SET:PCO 10"
OUTPUT @Hp4155;":PAGE:STR:SET:PCO MAX"
OUTPUT @Hp4155;":PAGE:STR:SET:PCO?"
ENTER @Hp4155;A
OUTPUT @Hp4155;":PAGE:STR:SET:PCO? MAX"
ENTER @Hp4155;A
Agilent 4155C/4156C SCPI Command Reference, Edition 1
:PAGE:STRess:SETup:PCOunt
Explanation
specify the stress time by duration
specify the stress time by pulse count
Explanation
0 to 65535. 0 means free run.
SCPI Commands
5-271