Syntax
Parameter
Query response
Example
Syntax
Parameter
Query response
SCPI Commands
:SYSTem:BEEPer:STATe
:SYSTem:BEEPer:STATe
This command controls whether the beeper is enabled.
At *RST, this value is ON.
:SYSTem:BEEPer:STATe OFF | ON | 0 | 1
Parameter
Type
OFF or 0
boolean
ON or 1
boolean
0 | 1 <newline><^END>
OUTPUT @Hp4155;":SYST:BEEP:STAT ON"
OUTPUT @Hp4155;":SYST:BEEP:STAT?"
ENTER @Hp4155;A
:SYSTem:COMMunicate:GPIB:RDEVice:ADDRess
This command sets the GPIB bus address of hard copy.
This command does not affect the address of the peripheral device.
The 4155C/4156C sends hard copy data to the device which has specified GPIB bus
address.
At *RST, the value of this parameter is 1.
:SYSTem:COMMunicate:GPIB:RDEVice:ADDRess address | MINimum |
MAXimum
Parameter
Type
address
numeric
address <newline><^END>
address is NR1 response data.
5-302
Agilent 4155C/4156C SCPI Command Reference, Edition 1
Explanation
beeper is disabled
beeper is enabled
Explanation
0 to 30