Syntax
Parameter
Query response
Example
SCPI Commands
:HCOPy:PAGE:DIMensions:LLEFt
:HCOPy:PAGE:DIMensions:LLEFt
This command sets the lower left corner of the output region.
At *RST, the value of this parameter is (0,0).
:HCOPy:PAGE:DIMensions:LLEFt x | MINimum | MAXimum,
y | MINimum | MAXimum
Parameter
Type
x
numeric
y
numeric
x, y <newline><^END>
The data type of x and y are NR3 response data.
OUTPUT @Hp4155;":HCOP:PAGE:DIM:LLEF 10,90"
OUTPUT @Hp4155;":HCOP:PAGE:DIM:LLEF?"
ENTER @Hp4155;A,B
:HCOPy:PAGE:DIMensions:QUADrant<n>
This command sets LOWER LEFT and UPPER RIGHT so that the setup data is
printed on the upper right quarter, upper left quarter, lower left quarter, or lower
right quarter of the page.
A numeric suffix is required to specify the quadrant.
<n>
1
2
3
4
This command defines an event and thus has no *RST state or query form.
5-54
Agilent 4155C/4156C SCPI Command Reference, Edition 1
Explanation
percentage from the left side of the paper
percentage from the bottom of the paper
quadrant
upper right quarter
upper left quarter
lower left quarter
lower right quarter