Page:scontrol[:Measurement]:Repeat - Agilent Technologies 4155C Command Reference Manual

Syntax
Example
See also
Syntax
Example
See also

:PAGE:SCONtrol[:MEASurement]:REPeat

This command starts the REPeat measurement operation.
The executed measurement mode, SWEep or SAMPling, is selected by the
:PAGE:CHANnels[:CDEFinition]:MODE command.
This command changes the present display page to the GRAPH/LIST: LIST or
GRAPH/LIST: GRAPHICS page, which is selected by the
:PAGE:DISPlay[:SETup]:MODE command.
Executing this command is about the same as pressing Repeat front-panel key.
This command does not have query form.
:PAGE:SCONtrol [ :MEASurement] :REPeat
OUTPUT @Hp4155;":PAGE:SCON:REP"
:PAGE:CHANnels[:CDEFinition]:MODE and :PAGE:DISPlay[:SETup]:MODE
:PAGE:SCONtrol[:MEASurement]:SINGle
This command starts the SINGle measurement operation.
The executed measurement mode, SWEep or SAMPling, is selected by the
:PAGE:CHANnels[:CDEFinition]:MODE command.
This command changes the present display page to the GRAPH/LIST: LIST or
GRAPH/LIST: GRAPHICS page, which is selected by the
:PAGE:DISPlay[:SETup]:MODE command.
Executing this command is about the same as pressing Single front-panel key.
This command does not have query form.
:PAGE:SCONtrol [ :MEASurement] :SINGle
OUTPUT @Hp4155;":PAGE:SCON:SING"
:PAGE:CHANnels[:CDEFinition]:MODE and :PAGE:DISPlay[:SETup]:MODE
Agilent 4155C/4156C SCPI Command Reference, Edition 1
:PAGE:SCONtrol[:MEASurement]:REPeat
SCPI Commands
5-243