Page:measure[:Sweep]:Vard:pcompliance - Agilent Technologies 4155C Command Reference Manual

Syntax
Parameter
Query response
Example
SCPI Commands

:PAGE:MEASure[:SWEep]:VARD:PCOMpliance

:PAGE:MEASure[:SWEep]:VARD:PCOMpliance
This command sets the power compliance value of VARD.
If the unit type of VARD is VSU, this parameter is ignored.
You use this command only if there is an SMU whose function (FCTN) is VAR1'.
:PAGE:MEASure [ :SWEep] :VARD:PCOMPliance pcompliance | MINimum |
MAXimum
Parameter Type
pcompliance numeric
If SMU for VAR1' unit is set to VPULSE or IPULSE mode, you cannot set power
compliance for VAR1' unit.
pcompliance <newline><^END>
pcompliance is NR3 response data type.
OUTPUT @Hp4155;":PAGE:MEAS:VARD:PCOM 0.5"
OUTPUT @Hp4155;":PAGE:MEAS:VARD:PCOM MAX"
OUTPUT @Hp4155;":PAGE:MEAS:VARD:PCOM?"
ENTER @Hp4155;A
OUTPUT @Hp4155;":PAGE:MEAS:VARD:PCOM? MAX"
ENTER @Hp4155;A
5-238 Agilent 4155C/4156C SCPI Command Reference, Edition 1
Explanation
1E-3 to 20. The range of this value depends on
SMU type of VAR1'.