Page:channels[:Cdefinition]:Vsu<N>:Vname - Agilent Technologies 4155C Command Reference Manual

Syntax
Parameter
Query response
Example
Execution
Conditions
Syntax
Example
:PAGE:CHANnels[:CDEFinition]:VSU<n>:VNAMe
This command sets the VNAME of VSU<n>.
<n> is required to specify VSU number. Valid VSU numbers are VSU1 through
VSU2.
At *RST, this value is VSU<n>.
:PAGE:CHANnels [ :CDEFinition] :VSU<n>:VNAMe name
Parameter Type
name string
name <newline><^END>
name is the string response data, but does not contain double quote characters at the
beginning and end of the string.
OUTPUT @Hp4155;":PAGE:CHAN:VSU1:VNAME 'VD'"
OUTPUT @Hp4155;":PAGE:CHAN:VSU1:VNAME?"
ENTER @Hp4155;A$
:PAGE:CHANnels:MATrix:CONNection
This command sends the matrix connection setup to the Agilent E5250A Low
Leakage Switch Mainframe.
This command is executable only on the built-in IBASIC controller.
:PAGE:CHANnels:MATrix:CONNection
OUTPUT @Hp4155;":PAGE:CHAN:MAT:GPIB:ADDRESS 20"
OUTPUT @Hp4155;":PAGE:CHAN:MAT:CONTROL ON"
OUTPUT @Hp4155;":MMEM:DEST INTERNAL"
OUTPUT @Hp4155;":MMEM:LOAD:STAT 0,'SET1.MAT','DISK'"
DISP "MODIFY E5250A SETUP. THEN PRESS Continue."
PAUSE
DISP ""
OUTPUT @Hp4155;":PAGE:CHAN:MAT:CONN"
Agilent 4155C/4156C SCPI Command Reference, Edition 1
:PAGE:CHANnels[:CDEFinition]:VSU<n>:VNAMe
Explanation
String of up to 6 alphanumeric characters.
1 st character must be alphabet.
SCPI Commands
5-99