System:communicate:network:filer:set - Agilent Technologies 4155C Command Reference Manual

Syntax
Parameter
Query response
Example
See also

:SYSTem:COMMunicate:NETwork:FILEr:SET

This command is one of the commands to register the network drive setup. To
register a setup, the following commands must be entered:
• :SYSTem:COMMunicate:NETwork:FILEr:NET:NAME
• :SYSTem:COMMunicate:NETwork:FILEr:NET:IPADdress
• :SYSTem:COMMunicate:NETwork:FILEr:NET:DIRectory
• :SYSTem:COMMunicate:NETwork:FILEr:SET
You can register maximum 4 setups.
This command registers the network drive setup. The setup data is stored in the
internal memory. Query returns the present setting.
:SYSTem:COMMunicate:NETwork:FILEr:SET NET1 | NET2 | NET3 | NET4
Parameter Type
NET1 character
NET2 character
NET3 character
NET4 character
name, ipaddress, directory <newline><^END>
OUTPUT @Hp4155;":SYST:COMM:NET:FILE:SET NET1"
OUTPUT @Hp4155;":SYST:COMM:NET:FILE:SET? NET2"
ENTER @Hp4155;A$
:SYSTem:COMMunicate:NETwork:FILEr:DELete
Agilent 4155C/4156C SCPI Command Reference, Edition 1
:SYSTem:COMMunicate:NETwork:FILEr:SET
Explanation
Specifies register 1 to store the setup.
Specifies register 2 to store the setup.
Specifies register 3 to store the setup.
Specifies register 4 to store the setup.
SCPI Commands
5-307