Page:stress:setup:constant:smu<N>[:Source] - Agilent Technologies 4155C Command Reference Manual

Syntax
Parameter
Query response
Example
:PAGE:STRess:SETup:CONStant:SMU<n>[:SOURce]
This command sets the constant SOURCE value of SMU<n> for stress.
<n> is required to specify SMU number. Valid SMU numbers are SMU1 through
SMU6, depending on the configuration.
The mode of the specified SMU must be V or I.
At *RST, this value is:
SMU1
SMU2 to SMU4
:PAGE:STRess:SETup:CONStant:SMU<n> [ :SOURce] source | MINimum |
MAXimum
Parameter Type
source numeric
source <newline><^END>
source is NR3 response data type.
OUTPUT @Hp4155;":PAGE:STR:SET:CONS:SMU1 10"
OUTPUT @Hp4155;":PAGE:STR:SET:CONS:SMU1 MAX"
OUTPUT @Hp4155;":PAGE:STR:SET:CONS:SMU1?"
ENTER @Hp4155;A
OUTPUT @Hp4155;":PAGE:STR:SET:CONS:SMU1? MAX"
ENTER @Hp4155;A
Agilent 4155C/4156C SCPI Command Reference, Edition 1
:PAGE:STRess:SETup:CONStant:SMU<n>[:SOURce]
SMU
not defined
0 V
-200 to 200 V or -1 to 1 A. The range of this value
depends on the type of SMU.
SCPI Commands
SOURCE
Explanation
5-267