Page:scontrol:stop - Agilent Technologies 4155C Command Reference Manual

Syntax
Example
Syntax
Example
Syntax
Parameter
Query response
Example

:PAGE:SCONtrol:STOP

This command stops the currently executing operation (SWEEP, SAMPLING,
STRESS, or KNOB SWEEP).
Executing this command is about the same as pressing Stop front-panel key.
This command does not have query form.
:PAGE:SCONtrol:STOP
OUTPUT @Hp4155;":PAGE:SCON:STOP"
:PAGE:SCONtrol:STRess[:STARt]
This command starts the STRess force operation.
This command changes the present display page to the STRESS: STRESS FORCE
page.
Executing this command is about the same as pressing Stress front-panel key.
This command does not have query form.
:PAGE:SCONtrol:STRess [ :STARt]
OUTPUT @Hp4155;":PAGE:SCON:STR"
:PAGE:SCONtrol:TRIGger:INPut?
This command waits for the external trigger input and returns 1 just after detecting
trigger. This command has query form only.
:PAGE:SCONtrol:TRIGger:INPut? POSitive | NEGative | EITHer
Parameter Type
POSitive character
NEGative character
EITHer character
1 <newline><^END>
OUTPUT @Hp4155;":PAGE:SCON:TRIG:INP? POS"
ENTER @Hp4155;A
Agilent 4155C/4156C SCPI Command Reference, Edition 1
Explanation
positive slope is regarded as the trigger
negative slope is regarded as the trigger
positive or negative slope is regarded as the trigger
SCPI Commands
:PAGE:SCONtrol:STOP
5-245